02
Aug
Drive your Mitsubishi for 15 min to warm up the transmission fluid. It is an engine oil dipstick other cars will have some other things marked yellow as well.
You can add more by inserting a funnel into the tube the dipstick was withdrawn from and pouring a small amount of automatic transmission fluid into the pipe.
How to check the automatic transmission fluid. To check your automatic transmission fluid follow these steps. Pull out the dipstick. With the gearshift in Neutral or Park and the parking brake on let your engine run.
Dip the tip of your index finger into the fluid on the dipstick and rub the fluid between your. Wipe the dipstick off a clean rag reinsert it then remove it again to check fluid level. Reinsert the dipstick then remove it again to check the fluid level.
Typically the fluid should be within the crosshatch pattern if the level is correct. In addition to checking the level you should note the condition of the fluid. The automatic transmission fluid dipstick is usually located on the back of the engine.
It is usually shorter than the engine oil dipstick. You may want to shift the transmission briefly through each. Theres usually a lever on the inside of your car that pops the hood usually near the left hand side.
Find the automatic transmission fluid pipe. Step-By-Step Instructions For Checking Your Vehicles Transmission Fluid Park vehicle on level surface engage parking brake and start engine. Leave car in neutral or park.
Let engine warm up. Locate automatic transmission fluid dipstick typically near where the transmission or transaxle meets. Topping up draining and refilling automatic transmission fluid.
Top up the fluid levels through the dipstick tube using a small funnel. Add a little at a time and check the level frequently to avoid overfilling. Use a clean funnel and fill slowly.
Check the level to avoid overfilling. Park on a level surface set the parking brake and let the engine idle. Check your car owners manual though.
Firmly press down on. You can add more by inserting a funnel into the tube the dipstick was withdrawn from and pouring a small amount of automatic transmission fluid into the pipe. Check the level each time you add a little until the level is right between the two lines.
Add fluid while the engine is running in the proper gear for checking the fluid levels. A transmission fluid leak is the only reason for fluid loss. If a leak occurs take the vehicle to your dealer and have it repaired as soon as possible.
The vehicle is not equipped with a transmission fluid level dipstick. How To Check Mitsubishi Automatic Transmission Fluid Level. Drive your Mitsubishi for 15 min to warm up the transmission fluid.
Park your Mitsubishi on level ground and set the parking brakes. Start the engine and with the brakes applied move the transmission shifter between all the gears. Pull out the transmission fluid dipstick and place some fluid on your forefinger.
The fluid should be red pink or light brown in color. If you notice a different color or a strange consistency such as bubbles or a milky-tone there may be an issue with your transmission and you should have a mechanic take a look. Lower the vehicle and add the specified amount of automatic transmission fluid through the fillerdipstick tube.
Expect to need about 4 quarts but do not overfill. With the transmission in Park and the parking brake set run the engine at a fast idle for a minute but dont race it. This is a fan requested video that I wish Id have thought of years ago.
If youre having trouble finding the transmission dipstick on your vehicle or if yo. How to Check Oil Coolant Transmission Fluid and Brake Fluid. The service points in your car that your manufacturer will want you to check will mostly be marked with yellow.
It is an engine oil dipstick other cars will have some other things marked yellow as well. Procedures for this will be in your owners manual. Make sure that your Mazda transmission fluid level is between the Full and Low-level marks.
If the level is below the minimum mark add half a quartlitter via the same tube you used to check the level. Only used the recommended Mazda transmission fluid that is mentioned in your owners manual. Pull the dipstick out again and check the fluid level.
If the engine is cool it should be at the upper end of the COLD mark. If the engine is hot the level should be at the upper end of the HOT mark. If its lower you should add some amount of automatic transmission fluid.