28
Nov
Continue to fill the power steering fluid reservoir as it empties and catch the fluid from the return line in a pan. You can use your power steering pump to pump out the old fluid and install new fluid in the reservoir.
Helps to lift the front tires off the ground slightly or park it on cardboard so the tires can turn easier.
How to drain power steering fluid. Flushing your Fluid 1. Lift the vehicle using a jack and assure that the front wheels are raised to a sufficient height allowing you to. Locate and remove the catch tray under the power steering system.
Some cars will not have a catch tray. Drain the power steering fluid by disconnecting. Part 1 of 3.
Drain out the old fluid Drip Pan Funnel Gloves Jack Jack stands 2 Paper towelsrags Pliers Power Steering fluid Safety glasses Turkey baster Wide-mouthed plastic bottle Note. Make sure the power steering fluid is the correct type for your car as the pump wont function properly with. For a complete drain a power steering fluid flush get under the vehicle and look for a rubber hose connected to the power steering pump.
Use pliers to remove the clamp pull down the hose and let the rest of the fluid drain into your catch can. This can get messy so have the shop towels nearby. How to Change Power Steering Fluid Prepare to Change Your Cars Fluid.
Your first step is to find out what kind of fluid your vehicle needs to keep the. Drain the Old Power Steering Fluid Out. Your next step is to lift your car with a jack so the front wheels come up off.
Fill the Reservoir with. The second method is by removing the hose that connects the reservoir to the power steering pump. This will completely drain the reservoir of power steering fluid.
If you want to learn how to drain power steering fluid in a more efficient manner this is the method to use. You will need to raise the front of the car by using an appropriate jack. The pump and reservoir will drain naturally as will the rack.
You can move the steering wheel back and forth to push out the fluid. Alternatively you can loosen the drive belt and rotate the pump pulley by hand to make sure youve cleared out the fluid and see if you feel anything abnormal in the pump. To drain the power steering fluid your mechanic will disconnect the power steering hose that is located at the lowest spot in the car.
The old power steering fluid is drained out. Then the hose is reconnected and new fluid is added to the reservoir. Use the turkey baster method to remove the old power steering fluid.
Suck out all the dirty power steering fluid engine off as shown. Then refill the reservoir with fresh fluid. Start the engine and let it run for about 15 seconds.
Repeat the fluid swap procedure until youve used up the full quart. You can use your power steering pump to pump out the old fluid and install new fluid in the reservoir. The start your power steering flush pump all of the old fluid out of the reservoir then refill it with new clean power steering fluid.
Next locate a low-pressure line in your power steering system. You can try removing the return line from the power steering fluid reservoir and directing it to a drain pan. Have an assistant ready to add more fluid to the power steering reservoir and start the engine and let it idle.
Continue to fill the power steering fluid reservoir as it empties and catch the fluid from the return line in a pan. Have a companion turn the steering wheel from left to right. The fluid that runs to the steering wheel will drain from the steering system through the upper hose.
Continuing the left and right turning motions drain the remaining old dirty power steering fluid. Once it stops flowing turn off the engine immediately. I got the car started yesterday and the power steering was whining while running.
I took the cap off and a gush of air came out and the fluid looks like malted milk water in fluid. Keep in mind this car is a 9c1 option car so it has a PS cooler in front of the radiator. Use Valvoline Maxlife ATF each time.
Disconnect return line to reservoir. Not the line that goes to the pump 2. Plug reservoir inlet and direct drain return line into a container.
Fill reservoir with fresh fluid. Find the power steering fluid reservoir located against the firewall in the center of the engine bay. Wipe any residual dirt and debris from the top of the reservoir cap to prevent contaminants from entering the power steering system.
Remove the cap dipstick. Fill the reservoir to the full mark as indicated on the dipstick. You just turn the steering wheel back and forth many times with the engine off to pump out the fluid.
Helps to lift the front tires off the ground slightly or park it on cardboard so the tires can turn easier.